Tubular Systems, New Conveyors and Silos, and Other Crafting Suggestions

tdb

Well-Known Member
Joined
Feb 28, 2019
Messages
46
Likes
76
Points
120
#21
I'd say the angled conveyor for that hawkeye block should be a 1x1x1 half-block. It should be able to turn the plane of conveyance as well, so it would be like the GSO sloped conveyor, up conveyor and down conveyor rolled into one block. It would have a somewhat angular feel compared to the GSO counterparts, but that fits the Hawkeye theme.
 
Likes: Rafs

Rafs

Collecting the Infinity Terminals
Joined
Apr 4, 2019
Messages
166
Likes
753
Points
200
Age
27
#22
I see, but the problem is attach points. In manufactoring, all blocks need to be directly attached to interact with each other.
An angled conveyor can't be simultaneously able to attach to something under or in front of it, either it has an attach point in a solid block below to connect to something in front of it, or an attach point right below it pointing downwards to attach with a conveyor going up/down. See what I mean?
I'll have to do inner corner, outer corner and sloped pieces. No problem here, since this could have positive outcomes :)
 
Likes: harpo99999

tdb

Well-Known Member
Joined
Feb 28, 2019
Messages
46
Likes
76
Points
120
#23
Okay, I was not aware of that restriction. I guess it has to be separate blocks then.
 
Likes: Rafs